|
|
|
Who's Online
There currently are 5993 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
What can i say but i would have been lost without your support.
Thank You!
;
Très satisfait ! envoi rapide, Grand catalogue disponible. Many thanks !
;
Delivery came quite promptly and in a very readable format. Thank you.
;
I found my Clarion VRX8370R in the Camper I bought and I wasn't able for month to understand it.
The Owner Manual was perfect and just what I was searching for.
Thank you.
Leonardo
;
Very good copy of Manual, clear and easy to print off, arrived very promptly and reasonably priced.
Thanks, I will use you again.
INSTALLATION INSTRUCTIONS
Install the Console (optional) Install the Laundry Tower
WARNING
Excessive Weight Hazard Use two or more people to move and install laundry tower. Failure to do so can result in back or other injury.
1. Using two or more people, situate the laundry tower near its final location. Open the drawers to remove any contents stored inside. 2. Using a Phillips screwdriver, remove the 2 outside screws from the back of the laundry tower top panel and discard them.
WARNING
Excessive Weight Hazard Use two or more people to move and install laundry tower. Failure to do so can result in back or other injury.
1. Using two or more people, situate the laundry tower near its final location. Open the drawers to remove any contents stored inside. 2. To determine how far to extend the leveling feet, measure the height of the washer and/or dryer you are installing the laundry tower next to or between. NOTE: Refer to the laundry tower dimensions in �Location Requirements.� 3. Place a piece of cardboard on the floor and, using two or more people, lay the laundry tower on its side.
A
A. Outside screws
3. Attach the brackets to the back of the laundry tower using the screws (provided). Align the brackets so that the latch is pointing up. 4. Attach the console to the laundry tower. Align the locators on the console with the brackets and push down until the latches snap into place and the magnets on the bottom of the console attach to the top panel. NOTE: Once installed, the console can be removed only by removing the 2 console screws.
4. Turn all four feet out to the dimension determined in Step 2. 5. Using two or more people, return the laundry tower to the upright position. 6. Check the laundry tower height and levelness and adjust the feet as needed. 7. Once the laundry tower is at the appropriate height and is level, use a ����" (14 mm) open-end wrench to securely tighten all four locknuts against the laundry tower.
A
B
A
A. Locknut
A. Locator B. Latch
8. Using two or more people, slide the laundry tower into its final location and confirm height and levelness.
LAUNDRY TOWER CARE
To clean the interior and exterior: s Use a soft damp cloth or sponge to wipe up any spills. Occasionally wipe the surfaces of your laundry tower to help keep it looking new.
s
Use mild soap and water; do not use abrasive products. NOTE: Do not lift the front of the console off the laundry tower without first removing the console screws.
3
|
|
|
> |
|
