|
|
|
Who's Online
There currently are 5755 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thank´s for your help, I already recived these manual from you
;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
 ;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
Door and control panel trim
The metal trim around the door and the control panel can be cleaned with any nonabrasive cleansers such as Bon-Ami or soapy water; rinse well. Be careful not to use an excessive amount of water.
Control panel and oven door front
To clean, use any suitable glass cleaner or soapy water. To prevent moisture from getting behind the control panel, spray a cloth with glass cleaner then wipe the panel.
Control
knobs
The knobs on the control panel can be removed with the controls in the Off position. Pull each knob straight from the shaft. Wash knobs in warm soapy water or dishwasher; do not use abrasive cleansers or materials. To replace each knob, match flat part of knob opening with the spring on the shaft, returning in Off position.
To remove pull forward to the "stop" position; lift up on the front of the rack and pulJout,
___ __
Before replacing bulb, disconnect power to oven at the main fuse or circuit breaker paneL Be sure that the entire oven cavity including the light bulb is cool before attempting to remove,
To replace light bulb
t, Carefully remove the glass light lens and lone retainer by removing the two screws in the light lens retainer using a screwdriver. Note: The lightlens isseparate from the lightlens retainer. The two pieces will drop down into your hands at the same time. Do NOT remove the remaining two screws. To obtain firm grasp on bulb, wear protective rubber gloves. Remove byturning bulbto the left. Do not touch a hot oven light bulb with a damp cloth as bulb will break. Note: Ifthe bulb does break and you wish to remove it, be certain power supply is disconnected and wear protective gloves. You may contact your authorized Jenn-Air Service Contractor for service. Replace bulb with a 40 watt oven-rated appliance bulb. Bulb with brass base is recommended to prevent fusing of bulb into sosket. Place lighHensinside of light lens retainer. Holding the }ighUens and lens retainer in place, insert the two screws into the light lens retainer and tighten. 28
2.
3.
4.
|
|
|
> |
|
