|
|
|
Who's Online
There currently are 5571 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
manual de usuario perfecto y completo de buena calidad de impresion y muy detallado ideal !
 ;
It`s full copy of a service manual from url http://www.philips.owner-manuals.com/PM3216-service-manual-PHILIPS.html
;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
3. Lift the rear of the panel up and back. The oven bottom can be removed for standard cleaning of the oven. Before cleaning, make sure the oven is completely cool.
Removing the Oven Bottom
The lip at the front of the panel should clear the front frame of the oven cavity. 4. Lift the bottom up and out.
To Replace: To Remove:
1. Remove the oven racks. 2. Place fingers in the slots in the bottom panel. Reverse the steps above.
A
A. Lip
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call. s Is the burner damaged? Nothing will operate On models with caps, look for warped cap. Place cap, flat side down, on a flat surface. If cap wobbles noticeably, it is s Is the power outlet properly wired and polarized? warped. Place cap on different burner for further check of Try another outlet to check for proper wiring and polarity. warping. Replace warped cap. Contact a trained repair specialist if the condition does not improve. s Is the power supply cord unplugged? Plug into a properly grounded 3 prong outlet. s Is the air/gas mixture correct? Contact a designated service technician to check the air/gas s Has a household fuse blown, or has a circuit breaker mixture, or see the Installation Instructions. tripped? Replace the fuse or reset the circuit.
Surface burner makes popping noises Oven and/or cooktop surface burners will not operate
s s
Is the main or regulator gas shutoff valve in the off position? See the Installation Instructions. Is the range properly connected to the gas supply? Contact a trained repair specialist or see the Installation Instructions. Is this the first time the surface burners have been used? Turn on any one of the surface burner knobs to release air from the gas lines. Is the control knob set correctly? Push in knob before turning to a setting. Are the burner ports clogged? On sealed burner models, see �Sealed Surface Burners� section. On open burner models, see �Surface Burners� section.
s
Is the burner wet? Let it dry.
Cookware not level on cooktop
Is the range level? Level the range. See the Installation Instructions. Is the proper cookware being used? Use cookware with a flat bottom. See �Cookware� section.
s
s
s
s
Excessive heat around cookware on cooktop
s
s
Is the cookware the proper size? Use cookware about the same size as the surface cooking area, element or surface burner. Cookware should not extend more than 1" (2.5 cm) outside the cooking area. Are the right side surface burners rotated toward each other? See �Burner Rotation� section.
s
Surface burner flames are uneven, yellow and/or noisy
s
Are the burner ports clogged? On sealed burner models, see �Sealed Surface Burners� section. On open burner models, see �Surface Burners� section. On models with caps, are the burner caps positioned properly? See �Sealed Surface Burners� section.
Oven will not operate
s
Is the power outlet properly wired and polarized? Try another outlet to check for proper wiring and polarity. Is this the first time the oven has been used? Turn any one of the surface burner knobs on to release air from the gas lines.
s
s
13
|
|
|
> |
|
