WHIRLPOOL TGP325MQ0
Owner's Manual

Bakeware
The bakeware material affects cooking results. Follow manufacturer�s recommendations and use the bakeware size recommended in the recipe. Use the following chart as a guide. BAKEWARE/ RESULTS Light colored aluminum s Light golden crusts
s

Baking and Roasting
IMPORTANT: Never light the oven burner during a power failure. Never place food or cookware directly on the oven door or the oven bottom. When using the oven for the first time, it is necessary to turn any one of the surface burners on first to release air from the gas lines. Before baking and roasting, position racks according to the �Positioning Racks and Bakeware� section. To Bake or Roast: 1. Touch BAKE. Touch TEMP �up� or �down� arrow pads to set a temperature other than 350°F (177°C) in 5°F (3°C) amounts. The bake range can be set between 170°F and 500°F (77°C and 260°C). 2. Touch START/ENTER. The temperature can be changed at any time after this step by touching the TEMP �up� or �down� arrow pads. START/ ENTER does not need to be touched again. If baking/roasting while the Timer is counting down, the set baking/roasting temperature can be displayed for 5 seconds by touching BAKE. 3. Touch OFF/CANCEL when finished.

RECOMMENDATIONS

s

Use temperature and time recommended in recipe.

Even browning
s s s

Dark aluminum and other bakeware with dark, dull and/or nonstick finish s Brown, crisp crusts

May need to reduce baking temperatures 25°F (15°C). Use suggested baking time. For pies, breads and casseroles, use temperature recommended in recipe. Place rack in center of oven. Place in the bottom third of oven. May need to increase baking time.

s

Insulated cookie sheets or baking pans s Little or no bottom browning Stainless steel Light, golden s crusts
s

s s

Preheating
After START/ENTER is touched, the oven will enter a timed preheat conditioning cycle. The Temp, Bake, and On indicator lights will light up. The Electronic Oven Control automatically selects the conditioning cycle time based on the oven temperature selected. The conditioning cycle time will not change if the temperature is reset before the cycle countdown ends. The preheat conditioning cycle is complete and the oven is ready to use when a 1-second tone sounds, the cycle countdown ends, and the set temperature is displayed. Preheat temperatures are affected by varying factors such as room temperature and peak energy usage times. It is normal for the temperature showing on the display and the actual oven temperature to differ. Waiting an additional 10 minutes after the preheat conditioning time ends to put food in the oven is suggested when baking foods with leavening ingredients, such as yeast, baking powder, baking soda and eggs.

s

May need to increase baking time.

Uneven browning
s

Stoneware s Crisp crusts Ovenproof glassware, ceramic glass or ceramic s Brown, crisp crusts

Follow manufacturer�s instructions.

s

May need to reduce baking temperatures 25°F (15°C).

Broiling and Custom Broiling
BROILER

Oven Vent
1

The broiler is located below the oven door. The broiler pan and grid roll out for easy access. Always broil with the broiler and oven doors closed.
s

Do not step on or apply weight to the broiler door while it is open. Do not preheat broiler before use. Completely close broiler door during broiling. Do not use broiler drawer for storage. Use only the broiler pan and grid provided with the appliance. It is designed to drain juices and help prevent spatter and smoke. For proper draining, do not cover the grid with foil. The bottom of the pan may be lined with aluminum foil for easier cleaning. Trim excess fat to reduce spattering. Slit the remaining fat on the edges to prevent curling.

s

s s

1. Oven Vent
s

The oven vent releases hot air and moisture from the oven, and should not be blocked or covered. Doing so will cause poor air circulation, affecting cooking and cleaning results. Never set plastics, paper or other items that could melt or burn near the oven vent.

s

10