I did not have the manual for a Whirl Pool gas dryer, therefore I purchased it from Owner-manuals. This is exactly what I needed. Thank you for the service.
Operating your dryer properly assures the best dryinf results. This section gives you important information to help you to select a cycle, time and tertperature.
Before
starting
your
dryer
N DTE: If your dryer has a Consumer Buy Guide, remove it and place it with your Use alld Care Guide. Wipe out dryer drum with a d;rmp cloth before using to remove dust from slripping and storing.
Refer to the information below, and �Laundry Tips� on page 12 for control setting, sorting and loading information.
Starting
Starting your
or stopping
dryer
your
dryer
Close the door and select a cycle. Push the Start Button. See pages 6-8 for additional setting information. Your dryer automatically stops when a cycle ends. Open the dryer door or turn the Cycle Control Knob to OFF. Close the door; make new selection (if necessary). Push the Start Button.
Stopping dryer
and restarting
your
\x5! i\ @i$ -
NOTE: The Cycle Control Knob should point to
an OFF area when the dryer is not in use. If the dryer is stopped before the cycle is finished, turn the Cycle Control Knob to an OFF area.
Selecting
a cycle
Use your High Heat automatic cycle to dry most loads. See �Using the High Heat automatic cycle� and �Using the Timed (high heat) cycle� for more information. 1. Select a cycle by turning the Cycle Control Knob either way to a desired time or setting. 2. Stop when the indicator on the knob�s outer ring points to the setting you want. 3. Push the Start Button.
Changing a selection: 1. Turn the Cycle Control Knob to point to a
new setting. 2. Push the Start Button, if necessary.
