|
|
|
Who's Online
There currently are 5291 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It is perfect, exactly what we needed. It's like the paper version but less clutter.
 ;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
To Adjust Oven Temperature Calibration:
Meat Thermometer
On models without a temperature probe, use a meat thermometer to determine doneness of meat, poultry and fish. The internal temperature, not appearance, should be used to determine doneness. A meat thermometer is not supplied with this appliance. s Insert the thermometer into the center of the thickest portion of the meat or inner thigh or breast of poultry. The tip of the thermometer should not touch fat, bone or gristle.
s
1. Press and hold CLOCK until the oven display shows the current calibration, for example, �00,� if not yet adjusted, or about 5 seconds. 2. Press the �up� or �down� arrow pads to increase or to decrease the temperature in 5°F (3°C) amounts. The adjustment can be set between 35°F (19°C) and -35°F (-19°C). 3. Press CLOCK to enter the new temperature.
After reading the thermometer once, push it into the meat ½" (1.3 cm) more and read again. If the temperature drops, cook the meat or poultry longer. Check all meat, poultry and fish in 2 or 3 different places.
To Adjust Oven Temperature Calibration (on models with manual oven control):
1. Make sure the oven temperature control knob is in the Off position. Pull oven temperature control knob straight off and turn it over.
s
Oven Vent
A
2. Loosen the locking screws inside the oven temperature control knob.
A. Oven vent
B
The oven vent releases hot air and moisture from the oven, and should not be blocked or covered. Blocking or covering vent will cause poor air circulation, affecting cooking and cleaning results. Do not set plastics, paper or other items that could melt or burn near the oven vent. The element can be used when the oven is in use as long as the cookware does not extend more than ¹��" (1.3 cm) over the element.
A
A. Locking screws B. Notches
Oven Temperature Control
IMPORTANT: Do not use a thermometer to measure oven temperature because opening the oven door and element or burner cycling may give incorrect readings. The oven provides accurate temperatures; however, it may cook faster or slower than your previous oven, so the temperature calibration can be adjusted. It can be changed in Fahrenheit or Celsius. A minus sign means the oven will be cooler by the displayed amount. The absence of a minus sign means the oven will be warmer by the displayed amount. Use the following chart as a guide. ADJUSTMENT °F (ADJUSTMENT °C) 5° to 10°F (3° to 6°C) 15° to 20°F (9° to 12°C) 25° to 35°F (15° to 21°C) -5° to -10°F (-3° to -6°C) -15° to -20°F (-9° to -12°C) -25° to -35°F (-15° to -21°C) COOKS FOOD
3. Adjust temperature. To lower the temperature, hold the knob handle firmly and turn skirt counterclockwise to move the tooth a notch to the left. To raise the temperature, hold the knob handle firmly and turn the skirt clockwise to move the tooth a notch to the right. Each notch equals about 5°F (3°C).
A
B
...a little more ...moderately more ...much more ...a little less ...moderately less ...much less
C
A. Notches B. Tooth C. Skirt
4. Tighten the locking screws and replace knob.
9
|
|
|
> |
|
