|
Who's Online
There currently are 5698 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
;
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
;
Fast service, document is OK. Thanks! Searched for it long time.
;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
USING YOUR RANGE
TONES
Tones tell you if a function is entered correctly or not. They also tell you when a cycle is completed. To shut off all tones except the end-of-timer and error tones: Press and hold STOP TIME for 5 seconds. A short tone will sound to tell you the tones have been changed. Repeat to turn the tones back on. You will see �off� for 3 seconds when the tones are turned off and �on� for 3 seconds when they are turned on. To choose between high and low volume tones: Press and hold DELAY START TIME for 5 seconds. A short tone will sound to tell you the tones DELAY have been changed. Either �HI� or �LO� will START appear on the time display for 3 seconds to TIME show the volume you chose.
STOP TIME
BAKING/ROASTING
1. Place the racks where you need them. For more
Front
information, see �Positioning racks and pans� in �Using the Oven� earlier in this section.
IMPORTANT: Do not try to light the oven burner during a power failure. Never place food or cookware directly on the oven door or the oven bottom. When using the oven for the first time, it is necessary to light the surface burners first, to purge air from the gas lines.
Rear
2. Choose the bake setting.
PRESS
BAKE
YOU SEE
F
BAKE
3. Set the temperature (optional).
Do this step if you want to set a temperature other than 350°F. Press v to raise the temperature or w to lower the temperature in 5°F amounts. Use these pads until the desired temperature shows on the small display. 4. When roasting, put your food in the oven. You do not have to preheat the oven when roasting, unless your recipe recommends it. NOTE: The oven will cook normally even though the preheat conditioning timer is displayed.
PRESS
TEMP
YOU SEE
F
BAKE
(example for bake at 375°F)
Roasting meats and poultry
� For even cooking, place the meat on a rack in a
shallow pan. This keeps the meat out of the drippings and allows the heat to circulate better. � Use a meat thermometer for the most accurate doneness. Insert it so the tip is in the center of the largest muscle or thickest portion of the meat or poultry. Make sure the thermometer is not touching bone, fat, or the bottom of the pan.
14
|
|
|
> |
|