|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
;
Generally speaking good copy; a few pages too hard contrast...
Good service and communication.
;
I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
;
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
;
Clear and easy to read. All details as expected. Price acceptable , and quick delivery.
ice maker mold and lead to poor ice quality. If a softened water supply cannot be avoided, make sure the water softener is operating properly and is well maintained.
Removing
(on some models)
the ice maker
storage
bin
Remove, empty, and clean the storage bin if: l the ice dispenser has not, or will not, be used for a week or more. l a power failure causes ice in the bin to melt and freeze together. l the ice dispenser is not used regularly. To remove Ice bin: 1. Pull the covering panel out from the bottom and slide it to the rear.
2. Lift the signal arm so it clicks into the OFF (up) position. Ice can still be dispensed, but no more can be made.
3. Lii the front of the storage bin and pull it out. 4. Empty the ice bin. Use hot or warm water to melt the ice if necessary. Never use anythlng sharp to break up ice in the bin. This can damage the bin and dispenser mechanism. 5. Wash with mild detergent. Rinse well. Do not use harsh or abrasive cleaners or solvents. 6. When replacing the bin, make sure it is pushed in all the way. Then push the signal arm down to the ON position to restart ice production. 15
|
|
|
> |
|