|
|
|
Who's Online
There currently are 5981 guests and
2 members online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
;
Manual was complete and available promptly, since I had lost my original manual. Very good response.
;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
Care and Cleaning
Record all inspections and repairs for future reference.
Cleaning Splatter Shield
Changing Oven Light Bulb
CAUTION
To avoid oven cavity damage, do not operate oven without splatter shield in place. Arcing will damage oven cavity and antenna when operated without shield in place. Splatter shield keeps top of microwave oven cavity and antenna from becoming soiled. Clean soil from shield with damp cloth or clean with mild detergent and water. Remove splatter shield for easy cleaning. 1. Unplug oven before removing splatter shield to stop antenna from rotating. 2. Place fingers on front of shield, push forward, and down. � When removing and replacing splatter shield, be careful not to bend antenna.
CAUTION
To avoid electrical shock hazard unplug power cord or open circuit breaker to microwave oven before replacing light bulb. After replacing light bulb, reconnect power. To avoid burns and cuts, wear gloves to protect hands should bulb break. If hot, allow bulb to cool. Tools and Bulb � Protective gloves � Standard screwdriver � Light bulb rated 115-125 volt, 40 watt 1. Unplug oven. 2. Remove screw from back of oven and remove access cover. � See illustration below. 3. Remove bulb by turning counterclockwise, being careful not to burn fingers or break bulb. � Replace with bulb rated 115-125 volt, 40 watt. 4. Plug in oven.
Remove screw and cover to change light bulb.
3. Wash shield in hot, soapy water. Rinse and dry thoroughly. � Do not wash splatter shield in dishwasher. � Do not use abrasive cleaners. 4. Reinstall splatter shield by fitting tabs into slots at top of oven cavity back. Lift and press front of shield until shield snaps into place.
Cleaning Interior, Exterior, and Door
Clean microwave oven with mild detergent in warm water using soft sponge or cloth. Wring sponge or cloth to remove excess water before wiping equipment. If desired, boil a cup of water in microwave oven to loosen soil before cleaning. � Do not use abrasive cleansers or cleaners containing ammonia. These could damage finish. � Never pour water into microwave oven bottom. � Do not use water pressure type cleaning systems.
11
|
|
|
> |
|
