I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
Very well done!!!!! congratulations. It was a bit longer than usual the wiating time even if it was on time (in 24 hours).
Text excerpt from page 9 (click to view)
Adjusting the Oven Temperature
Control
Does your oven seem hotter or colder than your old oven? The temperature of your old oven may have shifted gradually without your noticing the change. Your new oven is properly adjusted to provide accurate temperatures. But wher compared to your orb oven, the new design may give you different results. If after using the oven for a period of time, you are not satisfied with the temperature settings, they can be adjusted by following these steps:
LOCKING
1. Pull the
Oven Temperature Control Knob straight off.
I. Loosen the locking screws inside the control knob. Note the posltlon of the notches.
TOOTW
NOTCHES
NOTCHES
TOOTH
3. To lower the temperature, move the tooth a notch closer to LO. Each notch equals about 10°F (5°C).
4. To raise the temperature, move the tooth a notch closer to HI. Eacl notch equals about 10°F(SC]. Tighten the locklng screws and replace the control knob.
