Thanks to Owner-Manuals.com! This manual was exactly what I needed. As Amana was purchased by Maytag and later by Whirlpool, there was no way to receive it from their websites. I was lucky to find this resource.
A comprehensive Operating and Service Manual. All schematics are complete and easy to read. The PCB drawings and complete parts list are very helpful. I would definitely recommend this manual.
Text excerpt from page 13 (click to view)
Adjusting
the oven temperature
Locking
control
/Tooth To lower
Although your new oven is properly adjusted to provide accurate temperatures, it may cook faster or slower than your old oven. If, after using the oven for a period of time, you are not satisfied with the baking/roasting results, you can change the temperature calibration by following these steps:
Notches 2. Loosen the locking screws inside the control knob. Note the position of the
1. Make sure the Oven Temperature
Control Knob is turned to the off position. Pull knob straight off and flip it over.
notches. 3. To lower the temperature, hold knob handle firmly and move the tooth a notch
counterclockwise. Each notch equals about 5°F (2.5%). 4. To raise the temperature, hold knob handle firmly and move the tooth a notch clockwise. Each notch equals about 5°F
(2.5%). 5. Tighten the locking screws and replace
the control knob.
NOTE: DO NOT measure oven temperature
with a thermometer. Opening the oven door will lower the oven temperature and give you an inaccurate reading. Also, the thermometer temperature reading will change as your oven cycles.
