|
Who's Online
There currently are 6041 guests and 2 members online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Thank´s for your help, I already recived these manual from you
;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
S T AC K ING K IT INS T AL L AT ION
6. 1.
1)P osition the unit on a level surface, capable of supporting the entire weight of the dryer. R emember that the unit will be heavier when it is fully loaded. C lean the surface where the stacking kit is going to be installed. P lace the mounting bracket on the Washer as indicated.
2.
2) R emove the 2 plastic covers (shown in figure 6) attached to the middle of the stacking kit, and save these for later use. R emove the double back tape and firmly attach the stacking kit the top of the washer to assure the proper seal. Make sure the word F R ONT printed on the stacking kit is facing forward as shown above.
( back )
3.
4.
4) Install all 7 screws provided with a power drill and tighten the stacking kit to the unit base securely.
3) P ut back edge of stacking kit to back mold line of washer¡¯s top cover a nd tighte n the screw.
6) G ently push the dryer into position as indicated in figure 5 & 6, sliding the unit into the slots provided. It is important that the dryer is level. Make sure all four leveling legs are pushed all the way back into the slots to ensure proper mounting.
5.
5) Y our Dryer is equipped with 4 leveling legs. Make sure they are lowered 10 mm, so there is a gap between the legs and the dryer base.
6. 7.
7) Insert the plastic covers (removed in section 2) covering the two front slots of the leveling legs. Depending upon the location of the unit, it may be necessary to change the side on which the dryer door opens.
8.
DC 68-01052A
|
|
|
> |
|