|
Who's Online
There currently are 5911 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Absolutely perfect! I've been trying to understand how to use all or at least some of the features of the receiver and especially the remote.
;
Copy of genuine owners/operators manual, very useful
;
The manual was a perfect match and was exactly what I was looking for. I'm very satisfied with my purchase.
;
Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
;
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
Lint screen
The lint screen IS inside the dryer drum, on the back wall Clean it before each load. A screen blocked by lint Pull straight can Increase out. drying time. 1. Use the finger holes to pull the lint screen straight out 2. Lightly squeeze the body as shown, while pulling the cover off 3. Roll lint off the screen with your fingers DO NOT rinse or wash the screen. Wet 1 lint IS hard to remove Squeeze body; pull cover off. 4. Replace the cover on the body of the lint screen 5. Push the lint screen straight back In until it clicks into place
CAUTION: RUNNING THE DRYER WITH THE LINT SCREEN LOOSE, DAMAGED OR MISSING CAN CAUSE OVERHEATING, DAMAGE TO FABRICS AND DRYER PARTS, OR CREATE A FIRE HAZARD.
Lint removal
Lint can gather inside the dryer and create a fire hazard. This lint should be removed every 2 to 3 years, or more often, depending on dryer usage. A qualified service person is recommended for this job. I Unplug power supply cord. l Make sure dryer is cool. . Metal edges may be sharp. 1. Remove back panel from dryer 2. Avoid touching thermostats, wires, terminals and heater box. 3. Remove lint from shaded area - see art - with a soft brush or vacuum cleaner. 4. Replace back panel. Reconnect, exhaust duct, etc. Level the washer/drvec
l
Thermostats
Heater Box /
ExhIau Heat Element Terminals
|
|
|
> |
|