This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
Text excerpt from page 7 (click to view)
Lint screen
The lint screen is inside the dryer drum, on the back wall. Clean it before each load. A screen blocked by lint can increase drying time. 3. Roll lint off the screen with your fingers. DO NOT rinse or wash the screen. Wet lint is hard to remove.
Pull straight out.
Squeeze body; pull cover off.
1. Use the finger holes to pull the lint screen straight out. 2. Lightly squeeze the body, as shown, while pulling the cover off.
4. Replace the cover on the body of the lint screen. 5. Push the lint screen straight back in until it clicks into place.
Lint removal
Lint can gather inside the dryer and create a FIRE HAZARD. this lint should be removed at least every 2 to 3 years, or more often, depending on dryer usage.
ELECTRIC
DRYERS
GAS DRYERS
eaning should
be done only by a qualified
person.
1. Remove back panel (electric) or lower access panel (gas]. 2. Avoid damaging wires, thermostats, funnel or igniter. 3. Remove lint from shaded area see art-with a soft brush or vacuum cleaner. 4. Replace panel; reconnect and re-level dryer.