|
Who's Online
There currently are 5694 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Last week I bought a second hand BAUKNECHT TRK4850 DRYER. It is a professional machine with many programs and switch options. I feared it would be a huge quest to find a manual. I was delighted when I found owner-manuals.com. After payment I received the file to download the next day already. The quality is great. I am very happy. Thanks!
but kindly the distributions of the operating programs not find in the owners manual,can you help me to understand the operating programs instructions thank you
;
Very good copy, very readable and easy transaction as always.
;
It is perfect, exactly what we needed. It's like the paper version but less clutter.
;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Caring For Your Hot Water Dispenser
Energy-saving tips and preparation for periods of nonuse
On average, you will use your hot water dispenser to heat 7 to 8 cups of water per day. This uses only 19 kilowatt-hours of energy per month. So it is Not necessary to turn off the hot water dispenser each night to conserve energy. However, if the hot water dispenser will not be used for an extended period of time, follow these instructions:
For short periods (2-30 days of nonuse):
Set the Temperature Control to the �Off� position to conserve energy.
For long periods of nonuse (winterizing, seasonal storage or protection from freezing):
1. Turn Temperature Control to the �Off� position. 2. Unplug hot water dispenser power supply cord.
O-ring screw
When ready to use the dispenser again, follow Installation Instruction Steps 14-16, Page 9. Do Not Turn Unit On If Tank Is Empty. Damage to the unit will result and is not covered by the warranty.
3. Turn On/Off Cap, hold and run water until water is cold. 4. Turn saddle valve handle clockwise to turn off water supply. 5. Place a 3-quart minimum container under the drain plug at the bottom of the tank. 6. Use a screwdriver to remove the screw and O-ring from the drain tube. 7. Replace the screw and O-ring in the drain tube opening. Tighten the screw to reseal the drain.
Cleaning the spout screen
If you have very hard water, and you notice that the water flow is reduced, 1. Turn Temperature Control to the �Off� position. Push down and turn On/Off Cap clockwise and run water until it is cold to avoid possibility of burn. 2. Remove the two spout screws. 3. Remove spout base plate. 4. Pull the screen assembly out of the hot water tube. it may be necessary to clean the spout screen. 5. Use a small brush and vinegar to remove hard-water deposit. If deposit has hardened, soak in vinegar for an hour or two. Then use a brush to clean. 6. Replace screen assembly in tube. Reattach plate back onto spout. 7. Turn Temperature Control to the �Max� setting. The dispenser will be ready in about 15 minutes.
11
screws
base plate
|
|
|
> |
|