|
Who's Online
There currently are 5763 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Absolutely perfect! I've been trying to understand how to use all or at least some of the features of the receiver and especially the remote.
;
Copy of genuine owners/operators manual, very useful
;
The manual was a perfect match and was exactly what I was looking for. I'm very satisfied with my purchase.
;
Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
;
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
Adjusting the refrigerator shelves...
Shelves can be adjusted to match the way you use your refrigerator. Glass shelves are strong enough to hold bottles, milk and other heavy food items.
GLASS SHELVES ARE HEAVY. BE CAREFUL.
To remove glass shelves: 1. Tilt up at front. 2. Lift up at back. 3. Pull shelf straight out.
To replace glass shelves: 1. Guide the rear hooks into the slots in the shelf supports. 2. Tilt up front of shelf until hooks drop into slot. Lower front of shelf to level position.
Removing freezer shelf...
1. Lift front slightly. 2. Lift back off supports. 3. Replace in reverse order.
LlFl THE FRONT THEN THE BACK
Adjusting the door shelves...
TO remove
door
shelves:
To replace
door shelves:
1. Lift up shelf. 2. Tilt up at front. 3 PI 111 ch=rf straight out.
1. Tilt up front of shelf until hooks fit into slots in the shelf support. 2. Lower front of shelf to level position. 3. Push shelf down.
,P
I_
!,.:
r%.-.-~~I*---~ 1 i a�
To remove the crispers:
Li, :pIRhvli nyr&
Removing crispers and crisper co;eri::
PULL OUT TO STOP, LIFT THE FRONT AND PULL AGAIN
1. Slide crisper straight out to stop, lift front, then slide the rest of the way out. 2. Replace in the reverse order. To remove the cover: 1. Push up glass insert from bottom, then slide out with both hands. 2. Lift front of cover frame. 3. Lift out cover frame by pulling up and out. 4. Remove metal cover support. To replace the cover: 1. Replace metal cover support on wall supports in front section of cabinet. 2. Fit back of corner into notch supports on walls of refrigerator, then lower into place. 3. Slide back of glass insert into place, then lower front.
REMOVE THE
GLASS IS HEAVY. BE CAREFUL.
|
|
|
> |
|