|
Who's Online
There currently are 5706 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
High quality scan of the manual, very quick and easy download and very important, a truly honest price. thanks
;
Minden rendben, de két megjegyzés, az ábrák nehezen kivehetők és a fizetés után 24 órát kell várni a letöltésre.
;
Manual correct, and complete. Downloads cleanly. Format of manual was presumably difficult to PDF to A4, but works reasonably well.
;
This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
;
Fast and courteous service. Product delivered as described. Thank you.
1. Reach behind the control console 2. Remove bulb. 3. Replace with a 40-watt appliance
to find bulb. bulb.
Adjusting the refrigerator
shelves...
To remove shelves: 1. Tilt up at front. 2. Lift up at back. 3. Pull shelf straight out. To replace shelves: 1. Guide the rear hooks into the slots in the shelf supports. 2. Tilt up front of shelf until hooks drop into slot. Lower front of shelf to level position. To remove the meat pan and cover:
Shelves can be adjusted to match the way you use your refrigerator, Model ETlBVK has glass shelves. Glass shelves are heavy. Be careful.
Moving the meat pan and cover...
The meat pan can be taken out and moved the same way as the shelves. Remove the meat pan first.
1. Slide the meat pan out to stop. 2. Lift the front of meat pan. 3. Slide pan the rest of the way out. 4. Tilt cover up at front. 5. Lift up at back. 6. Pull straight out. To replace the meat pan and cover: 1. Guide the rear hooks of cover into the slots in the shelf supports. 2. Tilt up front of cover until rear hooks drop into slots. Lower front of cover to level position. 3. Replace meat pan in reverse order of removal.
Removing crispers and crisper cover...
iTo remove the crispers: 1. Slide crisper straight out to stop, lift front, then P:;L OUT TO STOP LlFl THE FRONT n�ND PULL AGAIN slide the rest of the way out. 2. Replace in the reverse order To remove the cover: 1. Push up glass insert from bottom, then slide out with both hands. 2. Lift front of cover frame and remove cover support. 3. Lift out cover frame by pulling up and out. To replace the cover: 1. Fit back of cover into notch supports on walls of 7 LIFT THE FRAk�iE FRONT, refrigerator, then lower front into place. 2. Replace cover support with the long tab towards the front NOTE: If the support needs adBE CAREFUL. justment, turn base right to raise, or left to lower. 3. Slide back front. 6 of glass insert into place, then lower
zw
-
|
|
|
> |
|