Exactly as described, the full user-manual (145 pages). Perfect.
Text excerpt from page 7 (click to view)
Reversing the door swing.. .
You can change the hinges on your refrigerator so the doors open the other way. Refer to the instruction sheet included with your refrigerator.
Removing and adjusting the freezer shelf...
To remove shelf:
1 Lift front slightly 2 Lift back off supports. 3 Replace In reverse order
To adjust shelf:
1 2 3. 4 Remove shelf Remove supports by sliding upwards Replace supports on desired level Replace shelf
Ice cube trays.. .
If cubes are not used, they may shrink The moving cold arr starts a slow evaporation. are stored, the smaller they get The longer cubes $2 To remove �. ice: 1. Hold tray at both ends 2. Slightly twist.
Optional automatic
ice maker.. .
l
If you have the automatic ice maker accessory or plan to add one later (Part No. ECKMF-83). there are a few things you will want to know: l The ON /OFF lever IS a wire srgnal arm. Down.. for making ice automatrcally: Up...to shut off the ice maker. l Shake the bin occasionally to keep cubes sepa rated, and to obtain increased storage capacity.
On
l
It is normal for Ice crescents to be attached by a corner. They will break apart easily. You will hear water running when Ice maker IS working. You�ll hear ice fall into the bin. Don�t let these sounds bother you. The ice maker will not operate until the freezer is cold enough to make ice. This can take overnight. Because of new plumbing connections. the first ice may be discolored OToff-flavored. Discard the first few batches of ice. If Ice is not being made fast enough and more ice is needed, turn the Refrigerator Control toward a higher number. Wait a day and, if necessary. turn the Freezer Control toward A. If you remove the ice bin, raise the signal arm to shut off the ice maker. When you return the bin. push it all the way in and lower the arm to the ON position. If cubes are stcxed too long, they may develop an off-flavor...like stale water. Throw them away. They WIII be replaced. Cubes In the Ice bin can alS0 become smaller by evaporation The ice maker water supply should not be softened water. The chemicals could damage the ice maker molds.
