Genuine Toshiba owner's manual. Couldn't really ask for more. And written in understandable English in contrast to a few recent experiences I have had with manuals for other equipment other than Toshiba but made in China and written in "Chinglish"!
I purchased a vintage Sony mixer off eBay and within the hour was able to locate and purchase the manual for it.I mean really,where else can you find a manual for a product made in 1983!? It was easy to find and purchase/download the manual I needed.I will use this site again for other equipment I have! Great site!
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
Text excerpt from page 9 (click to view)
Adjusting
the
EZ-TrackTM
refrigerator
shelf
The EZ-Track shelf slides from side to side for more flexible storage in your refrigerator. To slide shelf side-to-side: 1. Lift slightly on shelf front. 2. Slide to desired location. 3. Lower shelf front to level position. NOTE: You do not have to remove small items from the shelf before moving it side-to-side. You may need to remove larger items. /
Lif-l front slightly then slide to new location. Upper channel
To remove
the shelf:
1. Remove all items from the shelf.
2. Hold back of shelf with one hand. 3. Lift front of shelf to 45� angle. 4. Lower shelf slightly to release shelf from upper channel of track. Then pull shelf straight out. NOTE: Shelf is heavy. Make sure you use both hands when removing shelf.
Hold with both hands and lift front to 45� angle.
To remove shelf track: 1. Lift both sides of track slightly. 2. Pull track straight out.
Hold both sides and lift up and out.
To replace shelf track: 1. Guide track hooks into the shelf support slots on the back wall of the cabinet. NOTE: Make sure both track hooks are in slots and that the slots are parallel to each other. 2. Push track backward and down. 3. Check that track is completely seated in the shelf supports.
Make sure both sets of hooks are in support slots.