|
|
|
Who's Online
There currently are 5591 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
;
The manuel was exactly what I needed and I received it promptly. Thanks
;
Thanks to Owner-Manuals.com! This manual was exactly what I needed. As Amana was purchased by Maytag and later by Whirlpool, there was no way to receive it from their websites. I was lucky to find this resource.
2 Lift the signal arm so It clicks into the OFF posItIon. Ice can still be dispensed, but no more ~111be made TIPS l The dispensers door closed
l
WIII work only with the freezer
The Ice dispenser WIII work only if the bin IS pushed all the way In Use only ice crescents from the ice maker. Other shapes won�t dispense properly When you need more Ice than a glass or two, scoop it from the bin or remove the bin The dispenser motor may stop If the dlspenser bar IS held In too long It WIII be ready to run again in about 3 minutes Ice stored too long can go stale llke water Throw it away Ice can shrink Cold moving air slowly evaporates them If you use ice often. you may never notice the change 3 Lift the front of the storage bin Pull it out
l
l
l
l
Plan to remove and empty the storage bin: l If the Ice dispenser has not, or ~111 be used for a not week or more. l If a power failure causes Ice In the bin to melt and freeze iqether. l If the Ice dispenser IS not used regularly
4 Empty the bin Use hot or warm water to melt the Ice if necessary Never use anythlng sharp to break up Ice In the bin This can damage the bin and dispenser mechanism 5 Wash with mild detergent Rinse well Do not use harsh or abrasve cleansers or solvents. 6 When replacing the bin, make sure It IS pushed In all the way Push the slgnal arm down positlon to restart ice production to the ON
1 Pull the covering slide It to the rear
panel
�out from the bottom
and
The night light uses a heavy-duty IO-watt bulb It should last about 10,000 hours When It burns out. purchase another from your dealer
|
|
|
> |
|
