I did not have the manual for a Whirl Pool gas dryer, therefore I purchased it from Owner-manuals. This is exactly what I needed. Thank you for the service.
I was so pleased to get the owner`s manuel within one hour! Thanks again.
Regards
Werner
Text excerpt from page 6 (click to view)
Bottom View
Position the Air Conditioner
s s
Handle air conditioner with care. Be sure your air conditioner does not fall out of the opening during installation or removal. The place where the power cord exits the air conditioner should be no more than 4 ft (122 cm) from a grounded 3 prong outlet. Do not block the louvers on the front panel. Do not block the louvers on the outside of the air conditioner.
A B
A. Curtain housing B. Curtain guides
s
s s
3. Extend right-hand curtain outward so you may insert the first screw through the middle hole of the curtain. Using #8 - 18 x ³��" pan-head screw, screw curtain to middle hole in air conditioner cabinet. NOTE: This screw is required to correctly attach curtain (top to bottom) to the air conditioner cabinet.
1. Center air conditioner in window. Check that lower rail of air conditioner is behind and against back side of windowsill. Lower window sash to hold air conditioner in place.
A
A
A. #8 x ³��" pan-head screw A. Window sash
4. While the right-hand curtain is still extended, insert #8 x ³��" pan-head screws into the top and bottom slots of curtain. Screw curtain to top and bottom holes in air conditioner cabinet. NOTE: Some curtains may have 2 slots at each end. You will be able to see a mounting hole through the correct slot. 5. Slide curtain housing into guides as far as it will go. 6. Repeat above steps for left-hand curtain, then see �Position the Air Conditioner.�
2. Check that air conditioner cabinet is tilted to the outside so that water will run to the outside.
Models with side curtains (on some models)
1. Pull left-hand curtain out until it fits into the window channel. Repeat with right-hand curtain. If your air conditioner does not have side curtains, see �Models without side curtains.� Front View
Models without side curtains
1. Remove front cabinet screw from each side. 2. Place the short side of window-lock bracket against cabinet, and reattach front cabinet screw.
A B
A
A. Left curtain B. Window channel A. Window-lock bracket
3. Repeat for other side, then see �Position the Air Conditioner.�
