|
Who's Online
There currently are 5703 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Absolutely perfect! I've been trying to understand how to use all or at least some of the features of the receiver and especially the remote.
;
Copy of genuine owners/operators manual, very useful
;
The manual was a perfect match and was exactly what I was looking for. I'm very satisfied with my purchase.
;
Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
;
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
30120032GB.fm Page 14 Wednesday, August 29, 2007 5:25 PM
FITTING A D�COR DOOR TO THE APPLIANCE
The appliance front part has been fitted to accommodate the hinges so that the door can be opened either from the left or from the right hand side. Proceed as follows: 1. Screw the hinges onto the décor door, if a dummy drawer front is also being used ensure it to be fastened to the top edge of the door. Ensure the gap between door and drawer matches the units either side. 2. Fix the two hinge plates to the front of the washer dryer using the two plastic backing pieces. Note: an 8mm box spanner can be used to screw the thread cutting screws into position. 3. Fasten the two magnetic catches to the opposite side to the hinges and ensure the metal straps are fastened to the back of the door. 4. Locate the hinges on the door into the two hinge plates on the appliance. 5. If adjustment is necessary this can be achieved by either the hinge plates (vertical) or by the hinge fixing screws (horizontal).
FITTING A FULL HEIGHT DOOR
If a full height door is to be fitted (no dummy drawer front is being used) a top hinge hole has to be drilled in the door. The distance between the two hinge hole centres is 360 - 384mm and the distance from the edge of the door is 21.5mm. The hinge hole should be max 12mm deep and its diameter 35mm: make sure you do not drill through the door. The two fixing holes for the hinge screws are 2mm.
D�COR STRIP
A décor strip can be screwed into position on the edge of the washer dryer. If needed, the strip can be cut to be adjusted to your furniture but normally this will not be necessary.
TO LINE UP
TO DRILL
GB 14
Black process 45.0° 150.0 LPI
|
|
|
> |
|