Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.00 of store credit for Your review.
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.00 of store credit for Your review.
Good copy and great customer service! There was some confusion with my order and it was resolved promptly!
Text excerpt from page 4 (click to view)
INSTALLATION INSTRUCTIONS
WATER SUPPLY
� Water supply: cold water only � Tap: 3/4� threaded hose connection � Pressure: 100-1000 kPa (1-10 bar). Should the appliance be installed in a room which is subject to extremely low temperatures, you need to empty water at the end of each wash programme. Please follow the instructions given in the chapter titled �Draining Residual Water� and disconnect the water inlet hose.
WATER INLET HOSE(S)
1. Carefully screw the hose connection to the tap preferably by hand. Make sure there are no kinks in the hose and that it is not crushed. 2. Check water-tightness of tap and appliance connections by turning the tap completely on. � If the hose is too short, replace it with a suitable length of pressure resistant hose (1000 kPa min., EN 50084 approved type). � The appliance can be connected without a non-return valve. � Install the appliance in accordance with regulations of your local water company. For Great Britain & Ireland only: Water inlet: - hot (see A) fill hose; - and cold (see B) fill hose. The warm water inlet temperature must not exceed 60° C.
