|
Who's Online
There currently are 5713 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Thank´s for your help, I already recived these manual from you
;
Thank you for your manual It has the basic things to and i use the Oszi for Longer Time.
THX
;
Actually, I was looking for this information for 3 years!...now thanks to you, the manual is on my hands and of great help, cause I understand now where I was doing wrong connections and wires...excellent, I'll be back to you if in need, thank you.
;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
Converting 3 Wire to 4 Wire Power Cord
1. Remove rear wire cover. 2. Remove bottom strain relief screw and retain for further use. 3. Remove screw/hex nuts from terminal block and retain for further use. 4. Remove all 3-wire or cable leads from the terminal block and proceed to remove the power cord from the unit by pulling in a downward motion so that cord is removed from strain relief. 5. Remove the grounding strap attached to the center terminal on the terminal block. � Grounding strap is not needed for this installation. � Remove green ground screw and retain for future use. 6. To install the 4-wire cord, please follow step 4 through step 9 of Installing 4 Wire Cord. 7. Reinstall rear cover and secure it with screw removed earlier.
Anti-tip Bracket Installation
To reduce risk of range tipping, secure range with a properly installed anti-tip bracket. 1. Remove storage drawer from range. � See �Removing Storage Drawer� section. 2. Unscrew leveling legs so when range is moved into position range top clears counter top. � Left or right rear leveling leg must extend at least ¼ inch to engage bracket. � Anti-tip bracket can be installed on either right or left rear leveling leg.
or
3. Move range to where it will be installed. 4. Position anti-tip bracket. � With range in position, reach through storage drawer opening and slide anti-tip bracket on either left or right rear leveling leg. Slide leg into V-shaped notch in bracket. 5. Mark location of side and front of anti-tip bracket on floor. 6. Remove anti-tip bracket and range from opening. 7. Position anti-tip bracket according to lines marked on floor. 8. Mark 2 hole locations in anti-tip bracket. 9. Drill 2 holes. � If drilling into wood, use a 3/32 inch drill bit. � If drilling into concrete, use a 3/16 inch masonry drill bit and insert plastic anchors. 10. Secure bracket to floor using screws supplied. 11. Slide range into position. � See �Level Range� section of manual. 12. Confirm anti-tip bracket is engaged with range leveling leg and replace storage drawer.
10
|
|
|
> |
|