WHIRLPOOL ADP 659 WH
Quick Start

QUICK REFERENCE GUIDE
Attention Please read the operating manual prior to operating the machine for the first time.

GB
8

1

2

3

4

5
1 On/Off indicator light 2 Rinse aid level indicator light 3 Salt level indicator light

6

9
4 LED progress indicator lights 5 Programme selection Knob 6 Start/Pause button

7
7 Time Delay button

10
10 On/Off button

8 Time Delay indicator lights 9 Door handle

How to use your dishwasher:
Open the water tap. Plug to the mains. Open the door and load the dishwasher. Check if both upper and lower spray arms move freely. Fill enough detergent into the detergent dispenser and close the door. Use the on / off button to turn the machine on. Check the salt and rinse aid level indicator lights. If necessary, refill salt and/or rinse aid. Use the programme selection Knob to choose your washing programme.

Start the programme with the Start/Stop button: Attention Avoid opening the door during the washing process. This interrupts the washing process, and hot steam will escape. When the door is closed, the programme will continue. Use the on / off button to turn the machine off again. When the progress indicator light �programme end� lights up, the programme is complete. Close the water tap. Pull out the plug. Allow your dishes to cool for 15 minutes, with the door open. Unload the dishes. Begin with the lower basket.

PROGRAMME TABLE
Programme number

1

2

3 Reference **

4

5

Programme name

Pre-wash
Cleaning temperature

30 Min.

Eco

Normal

Intensive

Used dishes which are to be washed at a later time

35°C
Dessert and coffee dishes with food leftovers which are not dried on

50°C
Normally dirty dishes with starch containing food leftovers which are not dried on

60°C
Normally dirty dishes with food leftovers which are not dried on

70°C
Especially dirty dishes with food leftovers which are dried on

Suited to

Degree of dirtiness Detergents 15 cm³ 15-25 cm³ + 5 cm³

Pre-wash End

Few

medium

medium

High

x 35°C wash Cold rinse Cold rinse Dry End

x x
Pre-wash

x x 60°wash
Clear rinse Clear rinse Dry End

x x 50°C Pre-wash 70° wash
Cold rinse Cold rinse Dry End

50° wash
Clear rinse Clear rinse Dry End

Programme process

Duration (min) Energy (kWh) Water (I)

15 3,6

30 0,75 10,2

140 1,01 13

58 1,15 10,6

115 1,30 14,4

The consumption values shown in the table were determined under standard conditions. For this reason, deviations are possible under practical conditions. ** Reference programme for test institutes The tests in accordance with EN 50242 must be carried out with a full salt container of the water softener, a full reservoir for the rinse aid and the testing programme. Load capacity : 10