|
Who's Online
There currently are 5871 guests and 2 members online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Great scan but please note that it is entirely in GERMAN.
;
High quality scan of the manual, very quick and easy download and very important, a truly honest price. thanks
;
Minden rendben, de két megjegyzés, az ábrák nehezen kivehetők és a fizetés után 24 órát kell várni a letöltésre.
;
Manual correct, and complete. Downloads cleanly. Format of manual was presumably difficult to PDF to A4, but works reasonably well.
;
This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
1. To remove
outer cabinet,
o Disconnect power cord. D Take off the plastic grille. Remove the two screws at the bottom. Drop grille down ana take out
TOP FLANGE SCREWS
(side of cabinet)
c. Remove the socket head screws on each side and top flange screws (see illustrations). On 30, 40 and 48 pt. models, also remove rear grille. Pull out at bottom and drop grille down. d Lift cabinet from unit.
2. Coils should be inspected annually. If needed. brush clean with warm water and mild detergent. Rinse and dry. Be sure power supply cord is disconnected.
COILS
3. The compressor
IS sealed
and needs
no oiling
4. The fan motor is prelubricated and does not require further oiling under normal operating conditions. However, if the dehumidifier is operated under severe environmental conditions (dust, dirt, high temperatures) the fan motor should be oiled annually through the provided oil tubes (holes]. An easy to use capsule of especially recommended oil (Part Number 10943) IS available through your nearest Whirlpool Factory Service Center, or use SAE #20 nondetergent oil. 5. Wash plastic parts with a soft cloth, warm water and mild detergent. Rinse and dry with a soft cloth. 6. Replace cabinet supply cord. grille(s). Reconnect power
|
|
|
> |
|