Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
Text excerpt from page 4 (click to view)
Using the Energy Saver Control
1. Choose the desired fan setting-either FAN or NORM FAN. AUTO FAN....will save energy when AUTO
normal cooling and moisture removal are not needed. The fan will cycle on and off as the thermostat turns the compressor on and off. This saves the cost of electrical energy that would be used to run the fan continuously.
2. To bring in outside
air
Set control to FRESH AIR. Set FAN SPEED CONTROL to desired setting. Set the fan control to FAN ONLY if no cooling is desired.
NOTE: Energy efficiency is decreased when operating in either EXHAUST or FRESH AIR and cooling at the same time. Make sure the FRESH AIR/EXHAUST control is returned to the OFF setting when only cooling is desired.
It is normal
for the fan to turn on and off in
the AUTO FAN setting. The amount of time the unit will be off depends on room temperature and thermostat setting. when the weather is extremely warm or humid or when there are several people in the room. fan runs all the time even though the thermostat will turn the compressor on and off. Use NORM FAN during warm or humid weather and for rooms that need to be cooled constantly.
AUTO FAN is not suitable
NORM FAN....the
Using the Fresh Air/Exhaust
Control
This control setting can be used to draw stale smoky air from the room, or to draw fresh air from the outside into the room.
1. To exhaust
Set FAN SPEED CONTROL to desired setting. Set the fan control to FAN ONLY if no cooling is desired.
room air Set control to EXHAUST.
3. To circulate
room air Set control to OFF. Set FAN SPEED to FAN ONLY